The heat source selection of slime dryer is mainly divided into these types of fuels, solid, liquid, gas, electric power, etc. The method to maintain the average heating of the slime dryer is to adjust the production sequence of the equipment, and through the intermittent drying process, stagger the production stages of each part of the slime dryer to maintain the uniform heating of the slime dryer. So what can be done to make the slime dryer heat evenly? Let me share with you a few tips about the uniform heating of the slime dryer.
1. Reasonable operation monitoring of the equipment's dampers, and debugging the internal ventilation of the equipment. When the ventilation rate is too large, the use of air dampers should be postponed to ensure that the equipment firing zone operates under the correct wind pressure. In special circumstances, the air volume at the bottom of the equipment should be adjusted to reduce the peak. After suspending the use of the air damper, add materials with low moisture content to the slime dryer. After the internal temperature of the slime dryer stabilizes, the air damper can only be gradually restored, the fire will be advanced, and the slime dryer will be strengthened. The internal ventilation intensifies the use of fuel and increases the heat inside the equipment. When the air volume in the equipment is too small, increase the height of the air dam of the equipment so that the front part of the equipment burning zone is under negative pressure, and the rear part is burning under positive pressure. And to ensure the air volume of the internal heat preservation position and the cooling position, improve the quality of the fuel and the probability of heat exchange, and eliminate the occurrence of insufficient fire in the equipment.
2. Always check the temperature inside the equipment to compare the temperature of the slime drying equipment to the temperature of the dryer, and to limit it according to the amount of fuel added to ensure that the addition of fuel outside the slime dryer is carried out in a long flow of water to avoid excessive causes the temperature to be unqualified or too low to completely burn.
3. Reasonably add equipment fuel according to the change in heat production of equipment fuel. If the heat production value of the fuel at this stage is higher than the heat production value of the previous fuel, reduce the fuel addition. If the situation is opposite, increase the amount of fuel added to ensure that the slime dryer is evenly heated.
The above are some tips to keep the slime dryer heated evenly. Zhengzhou Dingli is a professional manufacturer of drying equipment. If you have any requirements for slime dryers, welcome to visit our factory.
