As a large-scale machine, the pomace dryer equipment will inevitably have some problems and failures in the production process. Users can deal with common problems and malfunctions. If the user cannot handle the serious fault, he can contact the manufacturer of the pomace dryer and ask a professional technician to solve it. Professional manufacturer, perfect after-sales service guarantee, rich experience in equipment troubleshooting, what are the common problems and solutions of pomace dryer equipment? The following editor will analyze it for everyone.
1. The belt conveyor has leakage problems when conveying materials.
The belt conveyor is an important auxiliary equipment in the pomace dryer, mainly used for conveying materials. If a large amount of material is scattered during the feeding process, there may be a problem with the belt tension, and you only need to adjust the belt in time. In addition, in the daily production process, it is necessary to check whether the gears and other parts of the conveying device are excessively worn and need to be replaced, and add lubricating oil in time to keep the parts sufficiently lubricated and flexible, and avoid excessive pressure on the contact surfaces of the parts. Damaged device.
2. Consider the impact of weather on the pomace dryer equipment.
In rain, snow or hot summer, attention should be paid to the impact of climate change on the pomace dryer equipment. The pomace dryer should be installed in the workshop as much as possible. If installed outdoors, a rainproof shed can be built to prevent rain and snow from affecting the drying operation. At the installation site, attention should be paid to drainage to prevent rainwater from accumulating, and at the same time, moisture-proof work of materials should be done to avoid increasing the difficulty of drying. Before the arrival of summer or winter, attention should be paid to formulate a sound and reasonable equipment operation plan and rain and snow weather preventive measures, and strengthen the training and assessment of operators.
3. The inspection door of chemical sludge drying equipment is cracked or deformed.
The inspection doors of some equipment are of poor quality and cannot withstand high temperatures. After long-term use, the inspection door will be cracked or deformed, making it impossible to close the inspection door. In response to this problem, it can be solved by manufacturing a new inspection door, which can be a 4 mm thick high-temperature steel plate.
4. Air leakage from dust removal equipment.
What should I do if the dust collector of the pomace dryer is running normally? Specific issues should be analyzed in detail. If it is caused by exhaust gas corrosion, the steel structure parts of the dust collector can be made of high-temperature anti-rust paint, and the elbow of the ventilation pipe can be cast with a wear-resistant layer to improve its corrosion resistance.
